HubenPower Regulator Tester

Related products

• 

  $30.00

  Intended for higher power builds

  High Travel Valve Stop For Umarex Gauntlet 1 or 2

  $30.00

  This part replaces part #19 and allows for greater valve dwell producing more power to be produced at higher regulator pressure settings.

  

  The .22 caliber HTVS for the Generation 1 Gauntlet fits both the .177 and .22.  Do not order Generation 1 HTVS for the Generation 2 Gauntlet, they are not the same

   

  Select options This product has multiple variants. The options may be chosen on the product page

• 

  $13.00 – $22.00Price range: $13.00 through $22.00

  For G1 G2 & G30 Variants

  Umarex Gauntlet Tune O-ring Kit

  $13.00 – $22.00Price range: $13.00 through $22.00

  Hajimoto Productions Tuning O-ring kit for the Gauntlet and Gauntlet 2

  Now includes two of my “NO RING” pellet probe seals as HP-1 rather than the typical high wear donut orings.

  

  I have put together the most common o-rings that fail during a tuning session. Most of the stock o-rings for the internals will gouge when the airgun is disassembled, this kit will allow you multiple attempts should any of the o-rings fail. Please note that the .30 caliber uses completely different internal o-rings than all previous Gauntlet Models including the .30 cal exclusive transfer port orings Which will be bagged as TP.

  Some of the NO-Ring seals have the leading edge precision ground.
  

  These tapered / precision ground types need to be installed as shown below

  

  (Images are of the .30 caliber NO RING)

  You get:

  • 2  of pellet probe NO-ring seals.
  • 2 sets of barrel o-rings.
  • 2 sets of tank block o-rings.
  • 2  of valve body o-rings.

  

  

   

  Select options This product has multiple variants. The options may be chosen on the product page

• 

  $45.00

  for .177, .22 and .25 NOT .30

  Umarex Gauntlet Strip Stak Pak (Bundle)

  $45.00

  Hajimoto Productions Strip Stak Pak for the Gauntlet 1 or 2. Not compatible with the Gauntlet .30 Caliber.
  An efficient multiport polymer air stripper that strips and channels air away from the pellet to allow for a more stable and less turbulent pellet launch from the muzzle. The HP Air stripper 2.0 comes with an o-ring. The kit also includes variable baffle chambers to help reduce both noise and turbulence in the airflow. The result is a more laminar air stream, which reduces projectile instability and, as a secondary benefit, reduces the report of the rifle.

  BAFFLES CAN NOT BE USED WITH DONNYFL SHORT SHROUD
  Because the Short Shroud is cut at a length that is a perfect fit for the air stripper and the spring. There is no room for the baffles in the DonnyFL Short Shroud.
  

  Polymer Air Stripper comes with o-ring and silicone grease for installation.
  

   

   

  Select options This product has multiple variants. The options may be chosen on the product page