Adapter for NateChrony V2
$14.00 – $18.00
A variable adapter for barrels that are not threaded. The variable adapter is simply pushed onto the end of the barrel & tightened in place with the thumb screws.
The bore & outer barrel MUST be concentric! Otherwise damage or injury could occur.
Select the maximum outer diameter of the barrel from the options. The adapters can be adjusted from its maximum diameter down to the minimum diameter by changing the internal inserts.
The barrel MUST make contact at FOUR points, as close as possible to the top & bottom of the barrel. If the adapter is making contact at the middle of the barrel mis-alignment can occur.
Thumb screws are aluminum & supplied with either knurled or printed tabs.
Price is for 1 adapter, with 1 set of screws.
Additional information
| Weight | 6 oz |
|---|---|
| Dimensions | 6.25 × 3.25 × 2 in |
| Size | 35mm-15mm (S), 45mm-15mm (L) |
You must be logged in to post a review.
Related products
-
$130.00 – $215.00for .177, .22 and .25 NOT .30
Gauntlet Short Shroud Combo
$130.00 – $215.00Select options
This part is designed and manufactured by DonnyFL for airgun use only
Part fits Gauntlet .177, 22 or the .25 caliber but does NOT fit the Gauntlet .30 caliber
Stock baffle spring must be used!
Remember to always order your suppressor one size larger for shrouded barrel PCP’s. DonnyFL Suppressors are sized so the first number is your PCP’s actual caliber and the second number is one size up. So if you owned a .22 caliber Gauntlet, the size you would select is .22/.25. If you had a .25 you would choose the .25/.30.If Your Gauntlet is:
- .177 Get a .177/.22 Supressor
- .22 Get a .22/.25 Supressor
- .25 Get a .25/.30 Supressor
Get it?
-
$47.00Air Stripper, Tension Spring and Baffle Stack
HP Strip Stak Pak for Avenger
$47.00Select optionsUPDATE: The newer avengers have a screw-on barrel shroud and an end cap that is a two-piece unscrewable but the STP still fits and works without an issue. unscrew the shroud rather than the little screw shown in the video and simply unscrew the baffle washer array off the end cap and you are good to go.
Strip Stak Pak for the Avenger
A six piece kit that includes an efficient multiport air stripper that strips and channels air away from the pellet to allow for a more stable and less turbulent pellet launch from the muzzle. The kit also provides baffle chambers to help remove both noise and turbulence in the air stream. The end result is a more laminar air stream which reduces projectile instability and as a secondary benefit, reduces the report of the rifle. This kit is 100% compatible with the stock end cap or the DonnyFL A50 adapter.
Air Stripper comes with o-ring and silicone grease for installation. The installation video for the Umarex Origin Strip Stak Pak is exactly the same so you can follow the installation video below.Replacement Air Stripper 0-ring is 14mm x 1.5mm
-
Sale!
$25.00 – $35.00Includes G1, G2, G30, G2SL, & G30SL variants
HP Barrel Band For Umarex Gauntlet
$25.00 – $35.00Select optionsAvailable in the classic Picatinny rail version or the 15mm thick rail less version.
Versions for Gauntlet 1, Gauntlet 2, Gauntlet 30 as well as the SL Versions!
Reviews
There are no reviews yet.