-
$4.00Ninja fill port o’ring
Fill Port O’ring Fits Ninja
$4.00Select options5 Dura 90 fill port o’rings that are a direct replacement for most Ninja Paintball regulators
-
$8.00Tank to PCP O-rings (10 Pak)
$8.00Select options10 Polyurethane CO2 / HPA Tank O-Rings (90 Durometer) The color is completely dependent on availability which will be RED or WHITE/TRANSLUCENT
-
$17.00Gauntlet 1 and Gauntlet 2
Umarex Gauntlet Tune O-ring Kit
$17.00Select optionsHajimoto Productions Tuning O-ring kit for the Gauntlet and Gauntlet 2
Now includes my “NO RING” pellet probe seals as HP-1 rather than the typical high wear donut orings.
I have put together the most common o-rings that fail during a tuning session. Most of the stock o-rings for the internals will gouge when the airgun is disassembled, this kit will allow you multiple attempts should any of the o-rings fail. Please note that the .30 caliber uses completely different internal o-rings than all previous Gauntlet Models including the .30 cal exclusive transfer port orings Which will be bagged as TP.
Some of the NO-Ring seals have the leading edge precision ground.
These tapered / precision ground types need to be installed as shown below
(Images are of the .30 caliber NO RING)
You get:
- 2 of pellet probe NO-ring seals.
- 2 sets of barrel o-rings.
- 2 sets of tank block o-rings.
- 2 of valve body o-rings.
-
$95.00Gauntlet O-ring service
$95.00Select optionsThis service tears the entire air rifle down, cleans and inspects for part wear, and replaces all the o-rings in your Gauntlet. Whether the o-rings are leaking from age or wear, whether the rifle is actually leaking or not, all o-rings are replaced. The rifle undergoes an incoming inspection which captures the functional and physical condition of the air rifle. This information is presented in a report which must be reviewed and approved prior to any work can begin.
The o- rings that are replaced are:-
- (2) Regulator to gun o-rings.
- (1) Stock end cap o-ring.
- (1) Stock air stripper o-ring.
- (1) Barrel to shroud support collar at breach block o-ring.
- (2) Bottle block to pressure tube o-rings.
- (1) Valve body o-ring.
- (2) Pellet probe o-rings.
- (3) Barrel to breach block o-rings.
The action is verified and lubricated prior to returning the rifle. The rifle undergoes a pressure test for 24 hours to guarantee there are no pressure losses.
-
