DISCLAIMER: This video is meant for educational & documentary purposes only. All work on airguns and airgun accessories should be carried out by a proficient licensed professional. Hajimoto Productions Channel nor YouTube will be held liable for any injury or damage resulting from attempting to duplicate anything shown in this video. By viewing this video, you are acknowledging the contents of this disclaimer.
In this video, I tear apart my .22 Benjamin Marauder Generation 2 PCP to swap out the heavy 36.5oz stock steel pressure tube with a lightweight 12.37oz Jefferson State Air Rifles Aluminum Pressure Cylinder.
The rifle will be torn down and reassembled with a JSAR Aluminum Air Cylinder, JSAR SS Balanced Valve, JSAR Super Hammer, JSAR TSS GEN2 and Huma regulator. The rifle will weigh almost 2 pounds less when this is all said and done. The MROD had most of these modifications already installed in the MROD but I never documented the installation but have been promising you guys that I would, well here it is!
I walk through every step and reference the Benjamin Marauder Schematic so you can follow along. All the parts other than the Huma Regulator for this build were purchased from Jefferson State Air Rifles. The Huma Regulator was from trenieroutdoors.com.
MARAUDER ALUMINUM AIR CYLINDER, GEN 2
http://www.jsairrifles.com/Marauder-A…
MARAUDER SUPER HAMMER
http://www.jsairrifles.com/Marauder-S…
MARAUDER TWIN SPRING SYSTEM (TSS) GEN 2
http://www.jsairrifles.com/Marauder-T…
HUMA REGULATOR BENJAMIN MARAUDER .22
https://www.trenieroutdoors.com/gear/…
If you have any questions about any of the parts you have seen in this video be sure to contact
Jefferson State Air Rifles at: sales@jsairrifles.com or
For Phone Orders Please Call: 1-833-257-2477 Extension 1
For Technical Support Please Call: 1-833-257-2477 Extension 2
Special Thanks to Travis Whitney for all your help man.
