Gauntlet 1 and Gauntlet 2
$17.00
Hajimoto Productions Tuning O-ring kit for the Gauntlet and Gauntlet 2
Now includes my “NO RING” pellet probe seals as HP-1 rather than the typical high wear donut orings.
I have put together the most common o-rings that fail during a tuning session. Most of the stock o-rings for the internals will gouge when the airgun is disassembled, this kit will allow you multiple attempts should any of the o-rings fail. Please note that the .30 caliber uses completely different internal o-rings than all previous Gauntlet Models including the .30 cal exclusive transfer port orings Which will be bagged as TP.
Some of the NO-Ring seals have the leading edge precision ground.
These tapered / precision ground types need to be installed as shown below
(Images are of the .30 caliber NO RING)
You get:
- 2 of pellet probe NO-ring seals.
- 2 sets of barrel o-rings.
- 2 sets of tank block o-rings.
- 2 of valve body o-rings.
Description
Remember, this o-ring kit supplies you with enough o-rings for two replacements not just one. This kit has been revised to include two of the low wear anti o-ring seals we call the NO Ring Pellet Probe Seal.
The below video demonstrates how to install the NO Ring on the .177, .22, and .25 caliber versions, the 30 caliber requires a different technique due to the relatively short ramp length of the pellet probe.
For the G30/G30SL Use a pencil or other tapered tool to prep the NO Ring for installation. It is beneficial to do this install in a warm location. The use of a hair dryer (not a torch or paint stripper gun) can be used to warm the material up for installation. Be sure to allow the NO-RING 15 mins rest time once installed before you close the bolt. This will allow the NO-RING to relax and shrink to the pellet probe before closing the bolt.
Lastly, the G30/G30SL NO Ring fits the bore very tight and will shear off a small amount of excess swell material the first time it is chambered. Use a pencil or other tapered tool to prep the NO Ring for the G30/G30SL because the cardboard technique just does not work as well for the G30/G30SL. You will need to preform and manually install the G30/G30SL NO Ring.
Related products
-
Gauntlet Flex Reg with 22ci Tank – Hajimoto Configurations
Hajimoto Flex Reg on 22ci Aluminum 3K for the G1
$205.00 Select options This product has multiple variants. The options may be chosen on the product page -
FX No Limit Scope Rings 1″, 30mm and 34mm
$79.00 – $99.00 Select options This product has multiple variants. The options may be chosen on the product page -
High Travel Valve Stop For Umarex Gauntlet 1 or 2
Intended for higher power builds
$30.00 Select options This product has multiple variants. The options may be chosen on the product page -
HP Air Stripper 2.0 For Umarex Gauntlet 1 and 2
$28.00 Select options This product has multiple variants. The options may be chosen on the product page
1 response